Bolting your SpiderPro Holster to a SpiderPro Belt

Step 1: use a 3/32 hex driver and remove the bottom two screws as shown in the image below.

Step 1

Step 2: clip on the Spider onto the belt--make sure the two holes in the belt align with the bottom "L" gaps in the Stainless Clip.

Step 2

Step 3: insert and screw in the two screws provided through the metal washers (the washers are optional) using a phillips head driver.

  • If using washers, make sure they sit under the Holster's back clip.
  • Make sure to apply force so that the screw threads into the back of the Spider - you will have to push the screws rather hard and bend the belt to accomplish this. It may help to place the belt on a table while doing this.
  • If you're having trouble threading the screws try angling them slightly inward.

Step 3

Step 4: make sure that the screws are threaded into the Spider base and are tightly pulling the base to the belt -- the belt pad should be bent a bit to reflect that.

Step 4

Step 5: check the back to make sure that the screws are in and are not loose in any way.

Step 5

That's it!